How to Refinish Hardwood Floors - Project Guide - Bob Vila - yabet333,亚博网站官网,亚搏娱乐官方网站

Watch Your Back

1/11

A ramp may be used to move heavy sanders from your vehicle to the ground, or from your porch through your threshold as shown here.

Joe Provey

Sanding the Floor

2/11

Sand as though you are mowing the lawn. Proceed row by row, overlapping runs by half the sander’s width. Unlike with mowing, however, you will have to make numerous passes with each grit.

Joe Provey

Sharpen Scraper

3/11

锐化你的刮刀机混蛋费尔e. Follow the manufacturer’s original bevel using a diagonal, slicing stroke.

Joe Provey

Shop Vac

4/11

Industrial vacs will do a better job, but save the rental fee and use your shop vac instead. Install a new filter and invest in a good brush attachment, if you don’t already have one.

Joe Provey

Wipe with Tack Cloth

5/11

A single wipe with a tack cloth removed a significant amount of dust, even after vacuuming.

Joe Provey

Lambswool Applicator

6/11

Use a lamb’s wool applicator (not foam) for applying shellac-based sealers.

Joe Provey

Cutting In

7/11

Use a brush to cut in around the room perimeter.

Joe Provey

Applying Stain

8/11

Applying stain (as well as sealer and polyurethane) is done using many of the same techniques you’d use when painting. Always begin your stroke a foot or two away from the area you’ve just coated. Then brush (or push applicator) to meet the previously stained area. This will help ensure even coverage.

Joe Provey

Remove Excess Stain

9/11

Follow up application by rubbing off excess stain with a rag. The goal is an even tone across the entire floor surface, although slight variations are perfectly acceptable.

Joe Provey

Applying Polyurethane

10/11

Apply polyurethane in two- or three-foot-wide parallel rows, each row overlapping the previous one. Make smoothing strokes (uninterrupted, continuous runs with the roller using light, even pressure) after completing each row. Avoid thick coats.

Joe Provey

Applying Polyurethane

11/11

Lightly sand between coats of polyurethane with very fine, 320-grit paper. A sanding pole makes it easier on your knees, but hand-sanding allows you to spot embedded debris. Wipe surface clean with a tack cloth or a rag dampened with mineral spirits before proceeding with the next coat.

Joe Provey

Don't Miss!

Clever project ideas and step-by-step tutorials delivered right to your inbox each and every Saturday morning—sign up todayfor the Weekend DIY Club newsletter!