Latest Discussions:Plumbing

richjones37

01:28PM | 11/11/11
Member Since: 08/29/06
13 lifetime posts
我所有的其他水龙头和浴缸都很好,所以我猜我的浴室水槽龙头搞砸了。这是你抬起手柄的那些之一,它们向左或右移动时移动。当我一路拉起/回来时,我几乎没有得到它的涓涓细流。是否有垫圈或某些需要更换的东西?

LarryG

04:28PM | 11/11/11
成员以来:07/22/04
649终身职位
The first thing I would try would be to remove the aerator on the tip of faucet then open the faucet. If you then get good flow you can be assured the aerator is plugged.

richjones37

11:03 AM |11/13/11
Member Since: 08/29/06
13 lifetime posts
Looks like it was the aerator. I went and bought a new one that looked identical, screwed it in, but now when i turn the water on full blast, water pours out under my sink. What did i do wrong?

LarryG

06:14AM | 11/14/11
成员以来:07/22/04
649终身职位
它与曝气机上的橡胶垫圈有关。旧的人还在龙头,或者你根本没有让它足够紧张。看看这个。

richjones37

09:26AM | 11/14/11
Member Since: 08/29/06
13 lifetime posts
正如我试图把旧的那样和同样的事情放在那样,水从曝气机顶部和水槽下面滴落在水槽下方的水槽上,也许不够紧张。我用钳子让它比我手的手甚至更紧,结果。我需要更换整个水龙头还是什么?

LarryG

04:38PM | 11/14/11
成员以来:07/22/04
649终身职位
I would say the washer isn't right or you left the old one still in there. You shouldn't need pliers to get it off or on if it's right in the first place. Or maybe you squeezed the new one and the old one out of round with the pliers. Gotta be careful. Some things are taken for understood. Sorry.

AndersonLive

02:09AM | 01/12/12
Member Since: 01/12/12
3 lifetime posts
Turn off the water that serves the hot water tap. Remove the handle and use a wrench to remove the stem from the faucet base. The stem will have a plastic cartridge with some o-rings around it or a washer at the bottom that presses against a metal seat inside the faucet tap or galvanized pipes. Material that impedes the flow of water is blocking it from passing through and you can probably find it there and remove it. If you inspect and find nothing at all, it may still have cleared up the problem by dislodging during the procedure you just followed.

BV001577

02:07PM | 07/16/13
just replaced a shower hose which was 8 or 11 mm (im not sure)with 16mm shower hose which cost me 7 pounds from screw fix and the problem is solved..ive got now a much more water pressure
。我在想改变新的水龙头,而且成本80磅,但这种简单的肉体为我修复了它

joechoniski

07:56AM | 07/24/13
成员以来:07/05/13
5个终身职位
Joe choniski 3
Low pressure bathroom sink faucetis a big problem. If the pressure is very low, than faucet may take long to get the job done. If the pressure is high, we concerned about wasting both water and money.

BV006939.

08:14AM | 02/09/15
Put a new faucet in. Works fine unless I turn it on full blast then loses almost all pressure. Something I did or bad faucet?

BV014378

03:17PM | 07/31/17
I was very skeptical that this was my problem, i just couldn't believe it was so simple. I went ahead and tried it and low and behold the filter was completely blocked with tiny lime and calcium "pebble" deposits! I was so happy not to have to call the plumber! I opened a business and I did have to call a plumber earlier as the mop sink trickled. There was a similar deposit about 3 inches long that was blocking all but a pin size flow. Thank You for the advice!

BV022262

08:45AM | 04/29/20
Cannot remove aerator bc it’s up inside bathroom faucet.. water pressure is bad with hot & cold.. How to remedy this if cannot unscrew aerator?

BV022331

10:28PM | 05/05/20
谷歌增氧机的关键。You'll need a specific size so look up your faucet size or but a multi pack. I found one on Amazon for less than $10.


Post a reply as匿名的

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply choose button

匿名的

Post new button 要么 Login button
Register